Application

Copper slag, steel shot, garnet: wrong abrasive, wrong profile

Blasting acceptance often checks only whether Sa2.5 was reached, not the profile. But profile is the physical basis of adhesion: too shallow and there is no key, too deep and the paint cannot fill it. ISO 8503 grades profile as fine, medium and coarse.

1. The character of four common abrasives

Copper slag: angular, hard, cheap, the most common bulk media. Deep, sharp profile, suited to thick-film heavy-duty work. Drawbacks are single use, heavy dust, and free silica requiring protection.

Steel shot: round, works by impact rather than cutting, gives a shallow even profile, mainly for removing mill scale. Alone it cannot produce deep profile, so it is blended with grit. Grit is angular and sharp, producing deep profile. The blend ratio sets the final result.

Garnet: angular, medium hardness, low dust, reusable a few times, medium-fine profile. Suited to stainless steel, galvanising and work needing a finer profile, at higher cost.

Alumina: hardest, deep profile, reusable, most expensive. Used for special requirements or where recovery economics matter in a fixed shop.

2. Matching abrasive to the system

Thick-film heavy duty (C5-M, immersion, 300 µm total or more): coarse profile from copper slag or a grit-heavy blend, 75–100 µm. Deep profile is what holds a thick film.

General industrial (C3–C4, 160–240 µm total): medium profile of 50–75 µm, copper slag or garnet both work.

Thin systems, galvanising and stainless: fine profile of 25–50 µm with garnet or a dedicated non-metallic media, avoiding iron contamination. In particular, never use steel media on stainless — iron contamination causes pitting.

3. Three practical points

Clean media. Oil- or salt-contaminated abrasive drives contamination straight into the surface, which is worse than not blasting at all. Sample imported media for salt.

Nozzle distance and angle. Typically 300–500 mm at 75–90 degrees. Too close embeds media and over-wears the surface; too far collapses productivity.

Consumption and top-up. Reused media gets finer and rounder, so profile shallows. Top up with new media at the consumption rate rather than only recirculating.

4. Measuring profile at acceptance

On site, compare against ISO 8503 roughness comparators by eye or touch — simple but subjective. More accurate are a stylus profile gauge or the replica tape method.

Record three things together: abrasive type, profile depth and Sa grade. Those plus salt make a complete surface preparation record. A record that says only Sa2.5 proves nothing.

Need selection advice?

Tell us your substrate and service conditions

One-to-one coating consultancy: system design, quantity take-off and quotation.

Contact us
WhatsApp