Application

Recoat intervals have a minimum and a maximum — overrunning the maximum is worse

Every TDS states two intervals: minimum recoat and maximum recoat. The first prevents solvent lifting, the second prevents the film hardening so far that the next coat cannot bond. Sites usually watch only the first.

1. What each interval prevents

The minimum lets the lower coat's solvent escape to a safe level. Recoating early re-dissolves the lower coat with the upper coat's solvent, producing lifting, wrinkling and colour difference. It is visible immediately, which is why people pay attention.

The maximum marks the point where the film is fully cured and the surface has densified, so a new coat can form neither chemical nor mechanical bond. Adhesion may be 30–50% of normal while the appearance is perfect — until a pull-off test, or until whole areas detach years later.

2. How long the maximum is

Epoxy is typically seven days at ambient, polyurethane three to seven, inorganic zinc sometimes only 24–48 hours. These figures are at standard temperature, 23 °C; warmer means shorter.

One accelerant is often missed: UV. Epoxy exposed to sun chalking far faster than indoors, and the maximum can halve. On outdoor staged work, recoating across days needs care.

3. What to do when it is exceeded

The standard treatment is abrasion — sanding or sweep blasting to break the chalked and densified surface and restore mechanical key, then removing dust before coating.

Note that abrasion restores mechanical adhesion, not chemical bonding. On demanding areas such as immersion or chemical service, full-area abrasion plus an adhesion check is safer than spot treatment.

4. Controlling the variable on site

Record completion time and temperature for each coat, calculate elapsed time, and check it against the maker's table. It sounds tedious and costs far less than rework.

On staged work, place the day-to-day joint at a structural break rather than wherever work stopped. Even if adhesion at a joint is slightly lower, it then sits somewhere less loaded and less exposed.

Need selection advice?

Tell us your substrate and service conditions

One-to-one coating consultancy: system design, quantity take-off and quotation.

Contact us
WhatsApp