The cost of one thick coat: three mechanisms behind thick-film cracking
Every maker prints a maximum per-coat thickness on the TDS. Most crews read it as advice. It is not advice — it is the physical limit at which the film can cure and shrink without cracking.
1. Mud cracking: dry outside, still shrinking inside
Fine reticulated cracks, like a dried riverbed. The surface skins over too fast while the interior still cures and shrinks, so the interior pulls the surface apart.
It favours high temperature, strong wind and direct sun, and can occur even within the maker's thickness limit when all three combine. Avoid by staying out of midday, shading or water curtains, and controlling ventilation.
2. Alligatoring: crosslink density too high
Larger, blocky alligator patterns with wide spacing. High-crosslink, low-flexibility systems — phenolic epoxy, inorganic zinc — applied too thick develop cure stress beyond tensile strength.
It often appears days to weeks after cure, not immediately. Judge by depth: surface only is recoverable; through to substrate means the whole film has failed.
3. Stress cracking: the substrate is moving
Straight cracks along welds, edges or structural transitions. The cause is not the paint but thermal or mechanical movement of the steel pulling the film apart, and a thick film is more brittle and cracks sooner.
Location separates it from the first two: always at a structural discontinuity, never mid-plate. Repairing paint alone does not fix it — relieve the stress concentration or introduce a flexible transition layer first.
4. Telling them apart
Shape first: fine reticulation is mud cracking, blocky is alligatoring, straight is stress. Position second: even across the area means application parameters, localised means substrate or structure. Then cut a section — depth sets the repair scope.
A quick field test: same batch, same day, if only the sunny face cracked it dried too fast; if only the thick areas cracked it is film build; if only welds cracked it is stress.
5. Repair and prevention
Surface cracks: abrade until none remain and recoat. Through cracks: strip to substrate, re-prepare and rebuild the system. Stress cracks: fix the structure first, then rebuild with a flexible system.
Prevention is three rules: stay within the maker's per-coat limit; shift working hours in heat and wind; control thickness strictly and build in layers on known-brittle systems. Do those and most remaining cracking comes from the substrate, not the paint.