Application

Can water jetting replace dry blasting? Depends whether you need a profile

In petrochemical units, tank internals and ship compartments, dry blasting is often impossible: dust contaminates the surroundings, sparks create ignition risk, and confined spaces are hard to ventilate. Water jetting is then the only realistic option. It is not, however, a like-for-like replacement.

1. What water jetting does

Removes paint, rust, salt and soluble contamination. At 1000–2500 bar it strips old coating and rust and washes salt off the surface — something blasting cannot do, and blasting may actually drive salt into pits.

ISO 8501-4 grades it Wa1, Wa2, Wa2½ and Wa3, corresponding to but not identical with the Sa grades. Wa2½ looks close to Sa2½ in practice, but the surface is matt and damp rather than the silver-grey metallic finish of blasting.

2. What it cannot do: profile

High-pressure water removes material without changing micro-texture. Smooth plate stays smooth; pitted plate keeps its pits, and profile depth depends on the original condition, uncontrolled.

That means: for maintenance overcoating where the existing profile is good and only the paint must go, water jetting is entirely adequate; for first-time coating of new steelwork, blasting is required to create profile. Get that premise wrong and adhesion becomes a serious problem.

3. Special requirements for wet surfaces

The surface is wet after jetting, and ordinary epoxy adheres poorly to damp steel. Use a surface-tolerant epoxy that displaces the water film and tolerates some flash rust.

There is also a window problem: steel flash-rusts quickly after jetting, especially in humid conditions. First coat is usually required within four hours. If that is impossible, use a corrosion inhibitor or a rust-converting primer, either of which needs separate validation.

4. How to choose

Water jetting: confined spaces, explosion-proof requirements, sensitive equipment nearby, salt removal needed, maintenance where existing profile is retained. Dry blasting: new steelwork, deep-profile thick-film systems, tight schedules, since blasting is faster.

A hybrid also exists: water jet to remove salt and old paint, dry, then sweep blast locally to establish profile. Higher cost, but it covers both requirements and suits demanding maintenance work.

Need selection advice?

Tell us your substrate and service conditions

One-to-one coating consultancy: system design, quantity take-off and quotation.

Contact us
WhatsApp