Jotamastic SF
Jotamastic SF is a Protective coating from Jotun. This page groups model identity, system position and the data request entry so you can verify the full system before enquiring.
Key technical data
| Volume solids | 99 ± 2% |
|---|---|
| Dry film thickness | 150–300 µm |
| Theoretical spreading rate | 6.1–3.1 m²/L |
| VOC | 115 g/L (US) |
| Density / specific gravity | 1.5 kg/L |
| Number of components | Two-component |
| Thinner | JOTUN Thinner No. 17 |
| Mixing ratio | 3 parts: 1 part: 2.2 parts: 1 part (by volume) |
The technical content below is reproduced in English as published by the manufacturer; terms, grades and values follow the English original.
How this coating class protects
Models filed here sit in the manufacturer's broad industrial protective coatings class without being narrowed to primer, intermediate or topcoat. It may be a companion product in a series or a coating for a specific service. So the first step is not reading parameters but fixing which layer of the system it occupies, which decides what it pairs with, how thick it goes and when it is applied.
What to verify in the original TDS
These are checking criteria, not numeric commitments. Every figure follows the current original TDS.
- Position in the coating systemPrimer, intermediate, topcoat or single coat. Without that, neither compatibility nor thickness can be judged.
- Corrosivity category and typical serviceThe ISO 12944 C1–C5 and Im1–Im3 scale is the common language. Without it, selection is guesswork.
- Manufacturer's recommended system above and belowCross-brand combinations need separate confirmation; in-system recommendations are the safest.
- Thickness, solids and theoretical spread rateThese three set consumption, price and coat count.
Application control points
Fix the system position before discussing price
The same model plays different roles in different systems, with different consumption and companions.
Ask for the full TDS, not a parameter summary
Summaries usually drop surface preparation, overcoating windows and curing conditions, which are exactly where site problems start.
Trial a small batch before scaling
For cross-brand substitution or a new service, run a small area and record thickness and ambient conditions.
How to settle site disputes
Guessing purpose from the model name
Naming differs by maker and literal meaning often misleads. Go by the recommended use in the TDS.
Swapping models within a category
Chemical resistance, temperature limits and curing can differ widely inside one category. Compare item by item before substituting.
Common questions on this coating class
Where can this model be used?
Can you supply the original TDS?
The above gives class-level technical requirements and judging methods. Specific values and systems follow the current original TDS and the project specification.
Place in the coating system
Primer–intermediate–topcoat layers and coat counts follow the exposure; DFT and curing conditions follow the original TDS and project specification.
Need the original TDS or a quote for this model?
Send the model, quantity, destination port and service conditions — we reply with a complete coating system, not a single can.