MODEL DATA

Jotun Thinner No. 26

BrandJotun
ModelJotun Thinner No. 26
CategoryThinner

Jotun Thinner No. 26 is a Thinner from Jotun. This page groups model identity, system position and the data request entry so you can verify the full system before enquiring.

Key technical data

Volume solids0%
VOC880 g/L (China)
Density / specific gravity0.9 kg/L
Number of componentsOne-component
Thinner5/20

The technical content below is reproduced in English as published by the manufacturer; terms, grades and values follow the English original.

How this coating class protects

A thinner is not just a solvent; it is part of the formulation. It sets the evaporation gradient, levelling, drying speed and final film quality. Wrong thinner or over-thinning is the most common and least traceable quality problem on site, because by the time it shows, the paint is already on the wall.

What to verify in the original TDS

These are checking criteria, not numeric commitments. Every figure follows the current original TDS.

  1. Which coating types it servesEach thinner matches a specific resin system. An epoxy thinner in a polyurethane can cause poor cure or precipitation.
  2. Maximum recommended additionData sheets give a volume ratio ceiling. Above it, thickness, weathering and adhesion all drop while the appearance stays normal.
  3. Evaporation rate (fast, slow, winter, summer)Slow grades prevent dry spray in heat; fast grades help drying in the cold. Seasonal formulations differ.
  4. Flash point and transport classificationHazardous goods storage and shipping requirements; exports need matching MSDS and transport assessment.

Application control points

Use only the specified thinner

Cross-brand mixing looks fine for weeks, then intercoat adhesion or gloss fails.

Measure by volume, not by eye

The site habit of pouring a little in is the main source of over-thinning. Use a measure or drum marks.

Use thinned paint within its working life

Stability drops once thinned; left standing it separates and lumps.

How to settle site disputes

Cheap solvent instead of the specified thinner

A small saving against the risk of recoating a whole elevation. That arithmetic belongs in the quote stage.

Over-thinning to cover more area

The industry's most common self-deception. Thin films cut service life proportionally, and testing is when it surfaces.

Common questions on this coating class

Are thinners interchangeable between brands?
Not by default. Even within epoxy systems the solvent blend can differ. Test a small sample before assuming.
Does thinner need an MSDS?
Yes. It has a flash point and a transport classification, and export clearance and shipping both need the MSDS and transport assessment.

The above gives class-level technical requirements and judging methods. Specific values and systems follow the current original TDS and the project specification.

Place in the coating system

Used for thinning and cleanup within a system, at the ratios and grades stated in the original TDS; not a protective coat on its own.

Need the original TDS or a quote for this model?

Send the model, quantity, destination port and service conditions — we reply with a complete coating system, not a single can.

← JOTUN Back to product catalog →

Other brands · same category

Need selection advice?

Tell us your substrate and service conditions

One-to-one coating consultancy: system design, quantity take-off and quotation.

Contact us
WhatsApp