Browse by category

Thinners: get the wrong one and no paint can be saved

A thinner is not just something that thins. Different resin systems need very different solvent polarity and evaporation rates; the wrong one costs you gloss or leaves the film permanently soft. 29 models.

What this category does in a system

Solvents fall into three classes: true solvents that dissolve the resin, co-solvents that assist dissolution, and diluents that only reduce viscosity without dissolving anything. Using diluent alone throws the resin out of solution as flocs or grit; the film loses continuity and corrosion protection drops to zero. The maker's recommended thinner is not a suggestion — it is part of the system.

Evaporation rate governs film quality. A high fast-solvent fraction dries the surface first and traps solvent beneath — skin-dry with a wet interior, leading to blistering, pinholes and poor adhesion. A high slow-solvent fraction levels well but sags, and in thick coats the retained solvent keeps the film soft for a long time. Summer and winter need different blends; taking last winter's thinner into summer is the classic failure.

There is an upper limit on addition, usually the maker's stated maximum (often 5–10%). Over-thinning to make spraying easier reduces film build and volume solids, pushes actual consumption past the theoretical figure, and ends with money saved on paint and lost on rework. Solvent-free and high-solids products generally permit no thinning at all.

One point is easily missed: thinner also cleans guns and lines. Wrong thinner in the gun leaves residue that contaminates the next batch — an incompatible solvent introduced directly into the paint. Cleaning and thinning with the same recommended thinner is the safe habit.

Need selection advice?

Tell us your substrate and service conditions

One-to-one coating consultancy: system design, quantity take-off and quotation.

Contact us
WhatsApp