ZD5100
ZD5100 is a Direct-to-metal coating from ZINDN. This page groups model identity, system position and the data request entry so you can verify the full system before enquiring.
Key technical data
| Volume solids | 50 ± 3% |
|---|---|
| Dry film thickness | 40/60/80 µm |
| Theoretical spreading rate | 0.192 kg/m² |
| Density / specific gravity | 1.2 ± 0.1 |
| Number of components | One-component |
| Thinner | Deionised water |
| Colour / appearance | Blue, red or custom colours |
The technical content below is reproduced in English as published by the manufacturer; terms, grades and values follow the English original.
How this coating class protects
Direct-to-metal combines primer and topcoat in one coat: fewer steps, less time, suited to tight schedules and moderate corrosivity. The trade-off is explicit: one coat carries adhesion, barrier and weathering at once, so all three are discounted. Fine below C3; above C4 you are buying schedule with service life.
What to verify in the original TDS
These are checking criteria, not numeric commitments. Every figure follows the current original TDS.
- Corrosivity category (ISO 12944)This is the first gate. DTM products usually state C2–C3, a few reach C4.
- Recommended and maximum single-coat thicknessSaving a step assumes the thickness lands in one pass. If it needs two, the saving disappears.
- Minimum surface preparationDTM often advertises low preparation, but the minimum grade still has to be stated.
- Weathering grade and colour retentionIt also acts as the topcoat, so weathering has to hold up.
Application control points
Getting thickness in one pass is everything
A single-coat system has no second chance. Uneven thickness decides where rust starts.
Still stripe coat the edges
Dropping the primer does not drop the stripe coat. Thin edges are the leading cause of single-coat failure.
Control conditions to topcoat standards
Because it doubles as the finish, appearance and cure demands are higher than a primer's.
How to settle site disputes
DTM in severe corrosivity
Nothing shows at first; two or three years later rust returns from edges and welds. Whole-life cost ends up higher.
Selling DTM as a universal paint
It solves process efficiency, not corrosivity class. Stating the boundary clearly matters more than making the sale.
Common questions on this coating class
Can DTM replace primer plus topcoat?
Why does DTM look more expensive?
The above gives class-level technical requirements and judging methods. Specific values and systems follow the current original TDS and the project specification.
Place in the coating system
Primer–intermediate–topcoat layers and coat counts follow the exposure; DFT and curing conditions follow the original TDS and project specification.
Need the original TDS or a quote for this model?
Send the model, quantity, destination port and service conditions — we reply with a complete coating system, not a single can.