Epoxy Bitumen Coating
Epoxy Bitumen Coating is a Epoxy bitumen from Hempel. This page groups model identity, system position and the data request entry so you can verify the full system before enquiring.
No published TDS parameters for this model yet; the original datasheet, including DFT, solids, mixing ratio and safety data, is available on request.
The technical content below is reproduced in English as published by the manufacturer; terms, grades and values follow the English original.
How this coating class protects
Bituminous coatings win on water resistance, resistance to dilute acids and alkalis, and cost. They are common on buried pipe, piling, sewage tanks and damp substrates. The limits are equally clear: poor solvent resistance, poor UV resistance, strong temperature sensitivity. Three questions decide fit: sunlight, solvents, temperature.
What to verify in the original TDS
These are checking criteria, not numeric commitments. Every figure follows the current original TDS.
- Epoxy-modified or straight bitumenEpoxy bitumen is clearly stronger mechanically and chemically, at higher cost. The two are not comparable.
- Temperature range (softening point and low-temperature embrittlement)Bitumen is temperature sensitive: it flows when hot and cracks when cold. Buried and exposed service differ.
- Whether a topcoat is requiredExposed to UV it ages, so a topcoat or a modified grade is needed.
- Tolerance of damp substratesSome products apply on damp surfaces, which is their advantage over epoxy, but damp is not the same as wet.
Application control points
Judge substrate moisture against the TDS
Damp tolerance has limits. Free water and seepage must be dealt with.
Build real thickness
The barrier comes from thickness. A thin bitumen coat achieves nothing.
Protect before backfill
Buried sections are easily damaged by stone during backfill; add a protection layer or bedding.
How to settle site disputes
Exposed use without a topcoat
UV ageing cracks the surface, water enters the cracks and protection ends.
Contact with solvents or oils
Bitumen dissolves or softens. Those environments need epoxy or glass flake.
Common questions on this coating class
Epoxy bitumen or straight bitumen?
Can bitumen be used in potable water tanks?
The above gives class-level technical requirements and judging methods. Specific values and systems follow the current original TDS and the project specification.
Place in the coating system
Primer–intermediate–topcoat layers and coat counts follow the exposure; DFT and curing conditions follow the original TDS and project specification.
Need the original TDS or a quote for this model?
Send the model, quantity, destination port and service conditions — we reply with a complete coating system, not a single can.