Browse by category

Bitumen: cheap and water-resistant, but it cannot take sunlight

Bitumen coatings offer exactly two things: low cost and resistance to water, dilute acids and salts. Right for buried, submerged and temporary protection; wrong for exposed atmosphere. 7 models, both epoxy bitumen and straight bitumen.

What this category does in a system

Straight bitumen (including coal tar) resists water very well, tolerates dilute acids, alkalis and salts, and costs little. It is used on buried pipe, piles, submerged members and as secondary protection in ballast tanks. Its weaknesses are equally definite: almost no weather resistance — it softens, runs and chalks in UV; poor solvent resistance, swelling on contact with diesel or petrol; and coal tar carries a polycyclic aromatic hydrocarbon issue that many projects now restrict.

Epoxy bitumen is the compromise: epoxy supplies strength and adhesion, bitumen supplies water resistance and flexibility. It costs more than straight bitumen but performs far better mechanically, and is common on submerged steelwork, buried pipe, wastewater basins and ballast tanks. The drawbacks are clear too — slow cure that barely proceeds at low temperature, so the schedule must allow for it, and black is the only colour, so no light topcoat is possible.

One rule is absolute with this family: any surface exposed to atmosphere needs a topcoat. Bitumen starts softening within about three months of UV exposure — not gradual ageing but visible deformation. Buried and submerged service is where it belongs.

Two points in application. The substrate must be dry: coating onto damp steel traps a water film and the whole layer peels within six months. Thickness is usually high (300 µm and above), and building it in one pass sags, so work in passes. Inspection focuses on thickness uniformity and missed areas.

Need selection advice?

Tell us your substrate and service conditions

One-to-one coating consultancy: system design, quantity take-off and quotation.

Contact us
WhatsApp