Energy

Coating system for offshore wind towers

Coating system for offshore wind towers

Coating system

LayerMaterial / systemDFTStandard
PrimerEpoxy zinc-rich or epoxy primer80 μmISO 12944-5
IntermediateHigh-solids MIO epoxy160 μmISO 12944-5
TopcoatAliphatic polyurethane or polysiloxane80 μmISO 12944-5
Total system DFT≥ 320 μm

Offshore tower exterior and transition piece: salt spray, UV and wind abrasion. Flanges and bolts reinforced separately.

Offshore wind towers face salt spray, wind-borne abrasion and UV exposure, with short maintenance windows and demanding recoat intervals. This project covers the tower exterior and foundation transition piece.

An epoxy zinc-rich or epoxy primer is used, with a high-solids micaceous iron epoxy intermediate and an aliphatic polyurethane or polysiloxane topcoat for colour and weatherability. Flanges and bolts receive local reinforcement.

All coating was completed in-factory; soft edge protection guarded the film during transport and erection. Site damage was repaired layer by layer with the same system, followed by holiday detection and DFT measurement.

The build-ups above are typical systems compiled from ISO 12944 and the relevant product technical data sheets; film thicknesses are reference values for the service conditions stated. For any specific project, the design specification, tender documents and the manufacturer's latest PDS govern. Actual performance depends on surface preparation grade, ambient conditions during application and recoat intervals.

← Projects
Need selection advice?

Tell us your substrate and service conditions

One-to-one coating consultancy: system design, quantity take-off and quotation.

Contact us
WhatsApp