Antifouling: you are buying fuel, not paint
Hull fouling raises roughness and can add double-digit percentages to fuel consumption; the whole economics of antifouling sits there. 137 models including self-polishing, controlled-depletion and copper-free systems.
Three variables decide the choice: speed and trading pattern, route water temperature and salinity, and idle ratio. For ocean-going ships running continuously above about 14 knots, self-polishing (SPC) systems renew the surface through water shear and perform best. For slow ships and harbour or construction vessels that sit idle often, controlled depletion (CDP) suits better because it does not rely on flow. Sensitive waters — California, parts of the Mediterranean, New Zealand — require copper-free or metal-free systems, and conventional products will be rejected on copper release.
Antifouling must never go directly onto the anticorrosive primer. Copper ions react with components of the primer, and the antifouling solvent attacks the coat beneath. The standard build is anticorrosive primer, tie coat, then antifouling; the tie coat both isolates and bonds, and skipping it is the most common cause of early failure.
Film thickness equals service life, but thicker is not better. Too thin and the design release rate is never reached; too thick and the film cracks and sheds as it shrinks on drying. Respect the maker's drying time before launch — launching early to catch a tide, with antifouling not fully cured, sheds large areas on the first leg. It happens every year.
One point is easily overlooked: accumulated thickness of old antifouling. Repeated dockings layer coat on coat, and once total DFT passes the maker's limit the whole build can delaminate under internal stress. At each docking, assess whether full removal is needed instead of adding another coat by default.
All models in this group
Grouped by brand. Open a model for technical data, system position and in-category alternatives.
CMP 42
JOTUN 31
HEMPEL 20
AKZONOBEL / INTERNATIONAL 14
PPG 13
NIPPON 11
Tell us your substrate and service conditions
One-to-one coating consultancy: system design, quantity take-off and quotation.