Alkyd: the oldest industrial paint, still indispensable in maintenance
Single component, excellent brushability, tolerance of St2/St3 surfaces and low cost — alkyd has not been displaced in maintenance work. 54 models.
Alkyd cures by oxidation, absorbing oxygen from the air to crosslink. That mechanism brings three benefits: no mixing ratio, outstanding brush levelling, and low surface preparation demands — hand or power tool cleaning to St2/St3 is enough. On old factories, railings and supports where blasting is impossible, that is a real advantage.
The limits are equally definite. First, poor alkali resistance: applied directly to new concrete, new galvanising or alkaline substrates it saponifies and peels, so a sealer or a different system is required. Second, poor water resistance — long immersion or high humidity blisters and lifts it. Third, oxidation drying means a heavy coat skins over while the interior stays wet, so work in passes with ventilation.
Where it belongs: structural steel, railings, pipe supports and tank exteriors in C2–C3 atmosphere. Where it does not: immersion, chemical media, marine splash zones. Put alkyd on coastal steelwork and you will see gloss loss and rust spotting within a year.
Application notes: the recoat window is shorter than epoxy, and overrunning it requires abrasion; confirm intercoat compatibility with epoxy and polyurethane (alkyd underneath with polyurethane on top usually works, the reverse does not); drying slows markedly in winter, so extend intervals.
Tell us your substrate and service conditions
One-to-one coating consultancy: system design, quantity take-off and quotation.