Browse by category

Insulation coatings: they reduce loss, they do not replace insulation

These coatings cut heat transfer through low-conductivity fillers or vacuum microspheres, used for burn protection, reducing heat loss and suppressing corrosion under insulation. Effective, within clear limits. 9 models.

What this category does in a system

The mechanism is a lower thermal conductivity in the film itself, so thermal resistance accumulates with thickness. Performance therefore depends heavily on build: a thin coat insulates almost nothing, and these products typically need hundreds of microns up to millimetres — they cannot be applied like a 60–80 µm topcoat.

Three genuine uses. First, personnel protection: bringing hot pipe and equipment surfaces down to a touchable temperature. Second, reducing heat loss where conventional insulation is awkward — steam lines, valves, flanges and other irregular shapes are slow to lag but quick to coat. Third, suppressing corrosion under insulation, since with no cladding there is no cavity to hold water.

The limit must be stated: it does not replace rock wool or calcium silicate. Matching the same thermal resistance with coating would need tens of times the thickness, and neither weight nor cost is realistic. It suits local treatment, irregular components, and supplementing an insulation system.

Three things to confirm when selecting: the continuous temperature ceiling (not the peak), weather resistance (outdoors it needs a topcoat), and volatile content — on hot equipment, retained volatiles blister on first heat-up. In application the key is uniform thickness: thin spots become thermal bridges.

Need selection advice?

Tell us your substrate and service conditions

One-to-one coating consultancy: system design, quantity take-off and quotation.

Contact us
WhatsApp