Fire protection: work out the fire rating first, then talk thickness
Fire protection is not 'apply it thicker and it is safer'. Fire resistance period, fire type and section factor decide the thickness, and a wrong calculation fails the test. 40 models.
Start with the type. Intumescent (thin-film) coatings foam on heating into a char layer tens of times thicker, insulating against cellulosic fire (Class A — offices, server rooms, residential). Non-intumescent (thick-film, cementitious) coatings insulate through their own low conductivity and suit hydrocarbon fire (pool and jet fire — petrochemical units, tank farms). Using intumescent on a hydrocarbon risk is a fundamental error: the char is blasted away by a jet fire.
Then the thickness. You cannot read it off a table indexed only by 'two hours' — it depends on the steel's section factor (Hp/A, heated perimeter over cross-sectional area). For the same two-hour requirement, a thick-walled H-section needs far less coating than a thin-walled or small section. Manufacturer tables are all based on Hp/A; feed in the wrong section data and the number is meaningless.
Compatibility is stricter than most people assume. Fire protection does not replace the anticorrosive primer and is not compatible with just any primer — intumescent films are highly sensitive to adhesion at the interface, and an oily, waxy or over-smooth primer causes wholesale detachment. The correct order is anticorrosive primer, fire protection, topcoat, with the primer approved by the coating maker.
Application and acceptance: non-intumescent grades are usually sprayed, and building full thickness in one pass cracks, so it goes on in controlled layers. Intumescent requires a flat surface with no sags. Beyond thickness, acceptance checks bond strength and appearance — voids in thick-film work are serious, because a voided area detaches in a fire and provides no protection at all.
All models in this group
Grouped by brand. Open a model for technical data, system position and in-category alternatives.
PPG 12
JOTUN 10
T&H 6
Tell us your substrate and service conditions
One-to-one coating consultancy: system design, quantity take-off and quotation.