Browse by category

Chlorinated rubber: fast, recoatable, and practical for maintenance

Fast drying, single component and tolerance of old paint keep chlorinated rubber in the maintenance market where plants cannot shut down for long. 18 models.

What this category does in a system

Its physical drying mechanism defines the behaviour: the film forms as solvent evaporates, with no chemical reaction, so at 20 °C it is touch-dry in half an hour and recoatable within hours. In equipment maintenance needing quick turnaround that speed is decisive — coat today, run tomorrow.

Tolerance of existing paint is the other selling point. Aged alkyd or epoxy, once abraded, can be overcoated directly without full removal, saving a great deal of surface preparation labour. On chemical plants, quays and older factories, that property is more useful than any datasheet number.

The drawbacks must be stated plainly: low volume solids (typically 30–40%), so more coats for the same DFT and high VOC; moderate weathering, with gloss loss and chalking after three to five years outdoors; poor solvent resistance, softening in aromatics and ketones; and a low temperature ceiling, generally 60–70 °C. New projects rarely specify it, and environmental rules keep tightening.

Two cautions. First, compatibility — it cannot go directly over old bitumen without lifting it. Second, the recoat window: a physically drying film densifies at the surface on prolonged exposure, so beyond the maker's interval you must abrade before recoating or intercoat adhesion will be short.

Need selection advice?

Tell us your substrate and service conditions

One-to-one coating consultancy: system design, quantity take-off and quotation.

Contact us
WhatsApp