Browse by category

Glass flake: stretching the diffusion path dozens of times over

Glass flake is one of the best value barrier technologies in heavy-duty protection — FGD absorbers, tank linings, wastewater basins, marine splash zones. It also has clear limits. 43 models.

What this category does in a system

The principle is simple: plate-like glass particles align parallel and stack in layers inside the film, so moisture and ions must travel around them and the diffusion path lengthens dozens of times. The price is high solids, high viscosity and heavy single-coat builds, which puts application demands a level above ordinary epoxy.

Typical uses are aggressive media at moderate temperature: wet FGD absorber internals, chemical tanks, wastewater basins, marine splash zones, tanking and secondary containment floors. The unsuitable cases are equally clear — thin decorative work, equipment with frequent thermal cycling, and flow paths subject to mechanical abrasion, where the brittle flakes are scoured away.

Three hard requirements in application. First, preparation to Sa2.5 with 50–80 µm anchor profile — the flakes key into the profile, and a shallow profile lets the whole film slide. Second, two coats in cross directions, otherwise the platelets align the same way and both barrier performance and crack resistance drop. Third, full cure: these are mostly solvent-free or high-solids, and residual monomer from incomplete cure destroys adhesion to the next layer.

Acceptance covers thickness uniformity, holiday testing (mandatory on linings) and degree of cure. Cure is usually judged by Barcol hardness or solvent rub; without instruments on site, a parallel test panel from the same batch is a workable reference.

All models in this group

Grouped by brand. Open a model for technical data, system position and in-category alternatives.

Need selection advice?

Tell us your substrate and service conditions

One-to-one coating consultancy: system design, quantity take-off and quotation.

Contact us
WhatsApp