Browse by category

Intermediate coats: build thickness without losing flexibility

The intermediate coat does two jobs — total film build, and lengthening the path corrosive media must travel. It is also the layer most often dropped to save money, and the one that fails first when it is. 44 models here, mostly micaceous iron oxide epoxies.

What this category does in a system

Micaceous iron oxide (MIO) is the classic lamellar filler for intermediate coats. Plate-like particles align parallel to the substrate, stretching the diffusion path for moisture, oxygen and chloride many times over, at modest cost and with forgiving application. That is why C4 and above, splash zones and immersed service almost always carry one.

An intermediate coat is not automatically required. In C3 or milder atmosphere with total DFT under 160 µm, primer plus topcoat is enough; forcing an extra coat in adds intercoat risk and schedule. The deciding factors are design life and corrosivity category: ISO 12944 C5-M, CX, or immersion Im2/Im3 effectively mandates it.

Two mistakes dominate. The first is trying to build thickness in one pass: 150 µm or more in a single coat traps solvent, leaving pinholes and retained solvent that blister within a couple of years. Two passes of 60–80 µm, respecting the maker's minimum interval, is the correct route. The second is overrunning the maximum recoat interval without abrading the surface — the next coat then merely sits on the previous one, with adhesion an order of magnitude worse.

Inspection should focus on thickness distribution rather than the average. MIO settles quickly, so poor agitation gives different thickness on the same panel; uneven gun distance and travel speed crack the thick areas and starve the thin ones. Statistical spot measurement per the 85-15 rule tells you far more than a single mean value.

All models in this group

Grouped by brand. Open a model for technical data, system position and in-category alternatives.

Need selection advice?

Tell us your substrate and service conditions

One-to-one coating consultancy: system design, quantity take-off and quotation.

Contact us
WhatsApp